Heliac Solar Inverter 2000 – 50A/24V
UTL Solar
Heliac Solar Inverter 2000 – 50A/24V is a solar hybrid inverter which utilizes both the Solar Power and Grid Power to charge the batteries with giving priority to solar power. Solar power is of the first priority while charging.
Specifications
| System Rating | 1650/50A |
|---|---|
| Capacity | 1500VA |
| Operating DC Voltage | 24V |
| Nominal Grid Voltage | 230V |
| Battery Low Buzzer | 10.8V |
| Battery Low Cut | 10.5V |
| Battery High Cut | 16.5V |
| Grid Charging Voltage (Equalize) | After 30Days |
| Grid Charging Current | 12A/15A |
| Grid Reconnect @ Battery Voltage | 11.8V |
| Output Phase | 1 Phase |
| Nominal Output Voltage | 220V±8% |
| Max. Output Current | 4.3A |
| Nominal Frequency | 50Hz±1% |
| Output Waveform | Sine wave |
| Typical Efficiency | 0.85 |
| Maximum PV Power Recommended | (315W/320W/325W)x4 |
| Solar current max | 50A |
| Solar current min | >3A (Below 3A, System will act like Solar Absent) |
| Protection | Overload, Battery Low, Battery High, Output Short, Battery Reverse, Over Heat, Over frequency, Under Frequency, SPV High. |
| LED Indication | System ON, (IT Mode, SMF/TUB, Boost Chg., DG Mode, Grid Chg.) Enable/Disable. |
| Switches | Reset for System ON/OFF, UP, Down, Back, Enter(For LCD Calibration) |
| Standard Compliance | IP20 |
| Weight | 15Kg |
| Dimension L x W x H | 300x265x165 mm |
As published by UTL Solar. We confirm figures that matter for your design against the current datasheet before you order.
Features
- PCU Mode Priority – Solar Energy → Battery → Grid
- Smart Mode Priority – Solar Energy → Grid → Battery
- Hybrid Mode – Priority for load → Grid → Solar Energy → Battery
- Priority for battery charging – Solar → Grid
About this product
Heliac Solar Inverter 2000 – 50A/24V has the following advance features like PWM solar charge controller, Most advanced Multi Color LCD Display, Maximum preference to solar, Built in IT Mode etc.
The frequency of DG output is a very vital parameter that always varies. And if the system is in DG enable mode then the system will be compatible to take any of the frequency as the input source frequency.